STARTER INSTALLATION INSTRUCTIONS
WARNING!!!!!!!!!!
Serious damage may occur to this unit
if these procedures are not followed.
• Disconnect the Negative (Ground) Battery Cable prior to removing the Starter.
• Remove the connections from the unit being replaced. Note the locations of the terminals.
• Charge the Battery with a Battery Charger. Test the Battery and replace if needed.
• Inspect the Battery Cables. Replace Copper Clad Aluminum Cables with Copper Cables. Never replace only the Cable Ends.
• Inspect the Ignition Wire as it connects to the Starter Solenoid.
(This wire may accumulate corrosion within 6 inches of the Solenoid)
• Compare the replacement unit to the Original Unit.
• Follow Warning Sticker Instructions that may be included with the Starter.
• Install replacement unit.
• Inspect and reattach original connections to the replacement unit.
• Change the Remote Solenoid, if applicable.
• Reattach all support brackets that may have been attached to the Original Unit.
• Do not over tighten the Solenoid Connections.
• Connect the Negative (Ground) Battery Cable.
• Start the Vehicle.
• Do not operate any Starter for more than 30 seconds without allowing time for proper cool down of the Starter.
How to Replace your Starter
When to Replace your Starter
How to Replace a Briggs & Stratton Starter Gear
